EasyManuals Logo

Symmetricom ET6000 User Manual

Symmetricom ET6000
206 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
GENERAL INFORMATION
PHASE NOISE
The following specifications are for the 10MHz sine wave output available on rear
panel BNC connectors J4-J9:
1Hz -72 dBc/Hz
10Hz -93 dBc/Hz
100 Hz -115 dBc/Hz
1KHz -126 dBc/Hz
10KHz -136 dBc/Hz
100 KHz -136 dBc/Hz
TEMPERATURE RANGE AND STABILITY
±1.0PPM from -30
o
to +75
o
C.
ADJUSTMENT RANGE
±3.0PPM minimum by internal manual trimmer.
VOLTAGE CONTROL
±3.0PPM minimum from +0.5 to +4.5 VDC.
B. LOW NOISE OVEN OSCILLATOR (Configuration –OCXO) with the
following specifications:
OUTPUT FREQUENCY/WAVEFORM
10MHz Sine Wave.
OUTPUT AMPLITUDE OF CRYSTAL OSCILLATOR
1.0 volt RMS into 50 ohms.
AGING RATE
±5 x 10
-10
per day, ±5 x 10
-8
per year.
TEMPERATURE STABILITY
±1 x 10
-8
over a temperature range of –20ºC to +75ºC.
OPERATING TEMPERATURE
–20ºC to +75ºC.
ALTITUDE
Sea level to +50,000 feet.
ELECTRICAL TUNING
±1PPM (minimum) / ±2PPM (maximum).
Symmetricom Inc ET6xxx ExacTime GPS TC & FG (Rev C) 1-9

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom ET6000 and is the answer not in the manual?

Symmetricom ET6000 Specifications

General IconGeneral
BrandSymmetricom
ModelET6000
CategoryReceiver
LanguageEnglish

Related product manuals