Synrad 32-1 - General Specifications

SYNRAD® 32-1 Operator’s Manual Version 2.2
51
Technical Reference
Parameter 32-1 (10.6 µm)
Output Specications
Wavelength (microns µm) 10.57µm-10.63 µm
†
Power Output 5 W
Power Stability
3
(Cold Start) ±15%
Mode Quality
3
M
2
≤ 1.2
Beam Diameter, mm (at 1/e
2
)
4
2.3 mm ± 0.5 mm
Beam Divergence, full angle < 8.0 mrad
Ellipticity < 1.2
Polarization Random
Rise Time (Measured at 1 kHz, 50% duty
cycle)
< 150 µs
Input Specications
Power Supply
Voltage 30 VDC ± 2.0 VDC
Maximum current 4.0 A
Input Signals
Frequency DC- 25kHz
Cooling Specications
Maximum Heat Load 150 Watts
Maximum Tube Temperature 60 °C
Minimum Flow Rate 150 CFM per fan two (2) required
Environmental Specications
Operating Ambient Temperature Range 5 °C - 40 °C
Humidity < 80% RH, non-condensing
Physical Specications
Length 11.2 in (284 mm)
Width 2.8 in (71 mm)
Height 4.2 in (106 mm)
Weight 7.0 lbs (3.18 kg)
Specications subject to change without notice.
† Typical. Actual wavelength range may vary from 10.2–10.8 µm.
1 This power level is guaranteed for 12 months regardless of operating hours.
2 Minimum 30 VDC input voltage to obtain guaranteed output power.
3 From cold start (guaranteed) at 95% duty cycle.
4 Measured at laser output.
5 32-1 lasers are designed to operate at a tickle frequency of 5 kHz, which allows the laser to meet published specications. Tickle frequencies lower than
4.5 kHz may compromise laser performance, particularly optical rise times, and stress the RF electronics thereby reducing long term reliability while
tickle frequencies greater than 5 kHz may cause laser emission.
6 FCC and CE tested at 5 kHz.
Table 4-9 Model 32-1 general specications.
General Specications