EasyManua.ls Logo

Synrad 32-1 - 32-1 Label Locations

Default Icon
62 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SYNRAD® 32-1 Operator’s Manual Version 2.2
20
Laser Safety
32-1 label locations
TOP VIEW
BOTTOM VIEW
CAUTION
These RF Excited Lasers must be provided with a
pre-ionizing "Tickle" signal during standby or
laser "low" periods. This is automatically provided
with Synrad's UC Series power controller. This signal
keeps the plasma ionized during laser "low" periods
and facilitates breakdown and pulse to pulse fidelity.
Damage or malfunction may occur if this or
equivalent drive signals are not used. See manual
for tickle pulse specifications or contact factory.
CAUTION
These RF Excited Lasers must be provided with a
pre-ionizing "Tickle" signal during standby or
laser "low" periods. This is automatically provided
with Synrad's UC Series power controller. This signal
keeps the plasma ionized during laser "low" periods
and facilitates breakdown and pulse to pulse fidelity.
Damage or malfunction may occur if this or
equivalent drive signals are not used. See manual
for tickle pulse specifications or contact factory.
MADE IN THE U.S.A.
MADE IN THE U.S.A.
MODEL #: 32-1SAC
SERIAL #: 0481263115066
TESTED AT
30 Volts MFG September 20, 2011
Complies with IEC 60825-1 (2007) and 21 CFR 1040.10 except
for deviations pursuant to Laser Notice No. 50 dated June 24, 2007.
SYNRAD, Inc. 4600 Campus Place, Mukilteo WA 98275 425.349.3500
This laser product is manufactured under
one or more of the following U.S. Patents:
6,195,379 6,198,758 6,198,759 6,603,794
6,614,826 7,480,323 9,031,110 9,197,028
Other U.S. and International Patents pending.
This laser product is manufactured under
one or more of the following U.S. Patents:
5,602,865 6,195,379 6,198,758 6,198,759
6,603,794 6,614,826 7,480,323
Other U.S. and International Patents pending.
FRONT VIEW
OEM version
MODEL #: MODELNUMBER
SERIAL #: SERIALNUMBER
MFG October 25, 2018
TESTED AT 48 Volts
This laser component does not comply with standards for complete laser products as
Specified by 21 CFR 1040.10 or IEC 60825-1
.
4600 Campus Place, Mukilteo WA 98275 | 425.349.3500
AVOID EXPOSURE
INVISIBLE LASER RADIATION
IS EMITTED FROM THIS
APERTURE
AVOID EXPOSURE
INVISIBLE LASER RADIATION
IS EMITTED FROM THIS
APERTURE
Figure 2-3 38-1 Hazard label locations.

Related product manuals