Synrad 48 Series - Page 7

table of contents
v
Synrad
Series 48Series 48
Series 48Series 48
Series 48 operator’s manual
List of Figures
Figure 1 48-1 hazard label and CE label locations ............................. 4
Figure 2 48-2 hazard label and CE label locations ............................. 5
Figure 3 48-5 hazard label and CE label locations ............................. 6
Figure 4 European compliance mark .................................................. 11
Figure 1-1 Series 48 shipping box contents ........................................... 1-4
Figure 1-2 48-1 / 48-2 cooling fan placement ....................................... 1-7
Figure 1-3 48-1 / 48-2 cooling connections ........................................... 1-10
Figure 1-4 48-5 cooling connections ..................................................... 1-11
Figure 1-5 DC-1 (Astec) power supply .................................................. 1-12
Figure 1-6 DC-2/DC-5 (Power-One) power supplies ............................ 1-13
Figure 1-7 Typical Series 48 system interconnection diagram .............. 1-16
Figure 2-1 48-1 / 48-2 controls and indicators ...................................... 2-2
Figure 2-2 48-5 controls and indicators ................................................. 2-3
Figure 3-1 Average laser output vs. percent PWM duty cycle .............. 3-2
Figure 3-2 Cross section of tube............................................................. 3-3
Figure 3-3 Beam characteristics ............................................................. 3-4
Figure 3-4 RF Driver IV ......................................................................... 3-6
Figure 3-5 “Flying optics” beam path..................................................... 3-7
Figure 3-6 Tickle pulse waveform .......................................................... 3-9
Figure 3-7 Series 48 waveforms.............................................................. 3-10
Figure 3-8 PWM Command signal waveform ....................................... 3-11
Figure 3-9 Factory-installed DB9 jumper plug wiring ........................... 3-14
Figure 3-10 Model 48-1 package outline and mounting dimensions ...... 3-20
Figure 3-11 Model 48-2 package outline and mounting dimensions ...... 3-21
Figure 3-12 Model 48-5 package outline and mounting dimensions ...... 3-22
Figure 4-1 Model J48 Series interconnect schematic ............................ 4-6
Figure 4-2 J Series control board schematic .......................................... 4-7
Figure A-1 Typical closed loop setup ..................................................... A-3