getting started
15
Synrad
Series 48Series 48
Series 48Series 48
Series 48 operator’s manual
Inventory
Contents description
Each item listed in Table 1-1 is described below.
SYNRAD Series 48 Laser – for cutting, welding, drilling, and marking a wide variety of products and
materials.
Series 48 Lasers Operator’s Manual – provides setup, operation, and maintenance information for your
Synrad Series 48 laser.
DB9 Connector and Cover Kit – connects to the Series 48 DB9 Connector. Use this connector to replace
the factory jumper plug when integrating Series 48 laser signals into your control system.
Spare Fuse(s) – fast-blow fuse protects Series 48 internal circuitry. A 10 A fuse is included with 48-1
lasers, a 20 A fuse with 48-2 lasers, and two 20 A fuses are shipped with 48-5 lasers.
Cooling Kit (water-cooled lasers only)
(48-1/48-2) – includes quick-disconnect inlet and outlet cooling manifolds, extra 1/4" union elbows,
extra straight 1/8" NPT to 1/4" tube fittings, and 20 feet of 1/4 inch O.D. black polyethylene tubing.
(48-5) – includes quick-disconnect inlet and outlet cooling manifolds, extra 1/4" union elbows, extra
straight 1/4" NPT to 3/8" tube fittings, and 20 feet of 3/8 inch O.D. black polyethylene tubing.
Final Test Report (not shown) – contains data collected during the laser’s final pre-shipment test.
To Next Page
Loading...
