getting started
13
Synrad
Series 48Series 48
Series 48Series 48
Series 48 operator’s manual
Unpacking
The Unpacking section includes subsections:
■ Incoming inspection
■ Packaging guidelines
Incoming inspection
Upon arrival, inspect all shipping containers for signs of damage. If you discover shipping damage,
document the damage (photographically if possible), then immediately notify the shipping carrier and
SYNRAD.
The shipping carrier is responsible for any damage occurring during transportation from SYNRAD, Inc.
to your receiving dock.
Carefully remove your Series 48 laser from the shipping container and remove the outer foam packing
material. Inspect the laser housing for any signs of shipping damage. Verify that all external labels are
attached to the housing (refer to label location drawings in the “Laser Safety” section). Contact
SYNRAD Customer Service if the laser housing is damaged or if any of the required accessory materials
or labels are missing.
Packaging guidelines
■ To prevent equipment damage or loss of small components, use care when removing packaging
materials.
■ Save all shipping containers and packaging materials, including covers and plugs. Use these special-
ized packing materials when shipping the laser to another location.
■ After unpacking, review the Inventory section and verify that all components are on hand.
■ When packing a laser for shipment, be sure to remove all accessory items not originally attached to
the laser including beam delivery components, cooling tubing, fittings, etc.
■ When shipping water-cooled lasers, remember to drain all cooling water from the laser and then cap
the open fittings to prevent debris from entering the coolant path.
■ Do not lift or support the laser using the cooling fittings; lift the laser by the mounting feet or
baseplate only.
To Next Page
Loading...
