IP30 Label Printing Scale Operation Manual
3.7. Power Connection
A) Connect the supplied power cable to the power connection socket of the scale.
B) Plug the power plug into a correctly grounded power outlet.
3.8. Start Up
Putting into operation.
The device has been installed properly and connected to the mains power supply.
The scale must not be loaded.
1) Once connected to the mains power supply ,the scale will be switched on automatically.
2) Switch on device
Power on: The power-on button is located below the scale.
Long press power-on button until hearing the
”
beep
”
sound and the scale is on.
3) Power off
To Next Page
Loading...
