When imaging, the destination media must first be formatted with a recognized filesystem.
Format destination drives by selecting the Format media utility in the Drive Details screen. The
Drive Details screen can be accessed through the Destinations button on the Home screen or
through the Select Destinations screen during setup of a duplication job.
If the destination drive is smaller than the source, a DD or DMG image will not fit on the
destination drive. However, if using Ex01 or E01, the source drive may fit on a smaller drive
because these formats can compress the data before writing to the destination drive. There is
no guarantee that the data will be compressed enough to fit on a smaller destination drive.
Note: Use extreme caution when attempting to copy a source drive to a smaller
destination drive.
Performing a Duplication
To perform a duplication:
1. Follow the steps listed in Connecting Drives on page30 to connect the source drive and
all relevant destination drives.
2. From the Home screen, tap the Duplicate icon. The Duplicate job setup screen displays.
36 Tableau TX1 User Guide Version 2.0
To Next Page
Loading...
