Error retry defines the number of times TX1 will attempt to read sectors with errors
before skipping the sector. Be careful when selecting a value of 10 or 100 as it will
drastically increase the duplication time when imaging source drives with errors.
7. If at least one destination Job type is image, then Step 5, Image Settings, displays as the
last step. To change the Image Settings, tap the 5 or Image Settings heading.
Image name defines the base filename for image segments. The default value is image.
Tap the Image name text area to change the filename, then select a File format and File
size.
Compression is enabled by default for Ex01 and E01 file formats, but can be disabled if
desired. Compression is not supported for DD and DMG file formats.
8. Once you are satisfied with your settings and drive selection, tap the Start Duplication
button.
CHAPTER 4 Using the TX1 43
To Next Page
Loading...
