Tait Orca 5000 - Spares Kits; Vehicle Kit Spares Kit (TOPA; Vehicle Kit Reskinning Kit (TOPA

F - 14 Tait Orca vehicle kit June 2003 IPN: M5000-00-105
Reassembling the vehicle kit
To assemble the vehicle kit, reverse the disas-
sembly process.
Note that when doing up the KC30x10 screws
the threads in the plastic PA moulding must
not
notnot
not be stripped. It is important that the audio
PA is held firmly against the backplate, as the
backplate serves as a heatsink.
Trigger reassembly
When reassembling the trigger assembly,
insert the peg moulding into the front panel.
Insert the quarter turn moulding and rotate it
until the peg moulding prevents it from
turning. Drop the two springs into the peg
moulding. While pressing in the trigger cap,
replace the trigger assembly.
While holding the trigger assembly cover togeth-
er (before doing up the screws) check that the
locking mechanism works correctly. To do this,
press in the locating pegs and check that the
trigger cap pops up. Press the trigger cap down
and check that the locating pegs pop out. If the
trigger assembly does not work correctly, check
that the quarter turn moulding is in the correct
position and repeat the assembly process.
Tighten the two KC30x10 trigger assembly
screws, while holding the trigger assembly in
place.
Rear cover reassembly
Locate the top of the rear cover into the back of
the trigger assembly. Press the bottom of the
rear cover to click/lock the cover into the front
moulding.
Spares kits
The following table shows a list of spares kits
which are currently available for servicing Tait
Orca vehicle kits. These can be ordered from
you local Tait dealer.
Table F-6: Vehicle kit spares kits
The contents of these kits are shown in Tables
F-6 and F-7.
Note that the ‘IPN’ column is the ten digit
‘internal part number’ which uniquely identi-
fies any component used in a Tait product.
The numbers in the ‘Legend’ column refer to
Figure numbers in which the spares item is
shown. The numbers in brackets refer to the
numbered legend within the figure, where
appropriate.
Product code Description
TOPA-SP-301 Vehicle kit spares kit
TOPA-SP-302 Vehicle kit reskinning kit