TM8100/TM8200 Service Manual TMAA02-08 Keypad Microphone 523
© Tait Electronics Limited November 2007
UI Preferences Form Select “Keypad Mic” in the Mic field.
Start-up Form In the Keypad Mic Mode field, select whether the keypad microphone is
in “Channel Control” mode or “DTMF Dialling” mode when the radio is
first turned on.
Note To toggle between channel control and DTMF dialling modes
when using the keypad microphone, program a function key for
“DTMF Dialling”.
Phone Patch form Select the Audible Phone Patch Side Tones check box to allow radio
users to hear the DTMF tones as they are transmitted.
23.2.2 Radios with a 3-Digit Control Head
As the radio does not need to be programmed to recognize the presence of
a keypad microphone, there are no fields in the programming application
that need to be configured. DTMF dialling is not available for radios with a
3-digit control head.
23.2.3 Radios with a Graphical Display Control Head
Conventional Mode If required, select the following check boxes:
■ Selcall Call Dialling in the Selcall Identity form
■ DTMF Call Dialling in the DTMF Signalling form
■ Phone Patch Call Dialling in the Phone Patch form.
Select an option in the Default Dialling Type field, Conventional UI
form. This sets the behaviour of the alphanumeric keys from the default
radio display.
Trunked Mode If required, select the check boxes:
■ DTMF Dialling in the Dialling tab of the Call Options form
■ PA BX Cal ls in the DTMF Call Dialling form
■ PSTN Calls in the Call Types tab of the Call Options form.
To Next Page
Loading...
