Tait TM8100 mobiles - TMAA04-05 Ignition Sense Kit; Hardware Configuration for Ignition Sense; Installation

TM8100/TM8200 Service Manual TMAA04-05 Ignition Sense Kit 579
© Tait Electronics Limited November 2007
30 TMAA04-05 Ignition Sense Kit
The TMAA04-05 ignition sense kit provides a
mating plug for the radio’s auxiliary connector.
The four metre length of cable from pin 4
(AUX_GPI3) of the plug connects to the vehicle’s
ignition signal.
Once the kit is installed, the ignition signal is used
to power up and power down the radio, so that
when the vehicle ignition is turned off, the radio
turns off. When the vehicle ignition is turned on,
the radio is programmed to either turn on, or to
return to the state that it was in when the vehicle
ignition was turned off.
Important The radio does not meet the IP54 protection standard once
the bung for the auxiliary connector is removed. Therefore,
once the
TMAA04-05 ignition sense kit is installed, mount
the radio in areas where it is not exposed to water, dust or
other environmental hazards
.
30.1 Hardware Configuration for Ignition Sense
The radio hardware link LK2 (on the top-side of the main PCB) must be
fitted for ignition sense operation. The following table and diagram describe
the configuration options.
Note
LK2 is fitted by default.
30.2 Installation
1. Connect the auxiliary connector plug to the radio’s
auxiliary connector.
2. Connect the ignition sense cable to the 13.8 V signal controlled by the
vehicle’s ignition key.
ignition sense cable
plug into the
radio’s auxiliary
connector
auxiliary connector plug
Table 30.1 Configuration of hardware links for ignition sense
Link required Voltages required for TMAA04-05
LK2 in
(factory default)
Ignition signal
≤ 0.9V (or floating) = off
Ignition signal
≥ 5V = on
Ignition-sense tolerant to 34V maximum