Tait TM8100 mobiles - Adjustment; Radio Programming

610 TMAA10-08 Desktop Microphone TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007
3. Squeeze the grommet and push the remaining corners into position.
4. Check that the grommet is seated correctly in the cavity.
37.3 Adjustment
Adjust the output level of the desktop
microphone using the control accessible from
the underside of the desktop microphone,.
The microphone sensitivity is set to maximum
by turning the control fully clockwise.
37.4 Radio Programming
UI Preferences form Check the settings of the following fields in the UI Preferences form of the
TM8100 or TM8200 programming application:
■ TM8100 radios: Set the Control Head Mic Gain field to Normal and
clear the Enable Options Board Preamp check box. These are both
default settings.
■ TM8200 radios: In the Audio tab, clear the Dynamic Mic Support
check box. This is the default setting.
Programming the
FUNCTION key
Program the FUNCTION key as follows:
1. Set the required action for the function key:
■ TM8100 radios: Assign a function to one of the function keys
in the Function Key Actions field in the Key Settings form.
■ TM8200 radios: Assign a function to one of the function keys
in the Function Key Actions field in the Conv Key Settings
form (conventional radios) or MPT Key Settings form
(trunking radios).
2. Set CH_GP101 to ‘Input’, ‘Active Low’ and assign the action
‘Simulate F1 to F4 Key’ (Programmable I/O form, Digital tab).
Figure 37.1 Correct desktop microphone grommet seating
microphone
grommet
control head
adjust output level here