Tait TM8100

TM8100/TM8200 Computer-Controlled Data Interface (CCDI) Protocol Manual CCDI 23
© Tait Electronics Limited April 2007
■ ‘c’ is sent as a single ASCII character and represents the CANCEL
command.
■ [CANCEL_TYPE] is a single ASCII character representing the
cancelling type.
Note If no [CANCEL_TYPE] is sent, then the CANCEL command
will default to CANCEL_TYPE = 0.
Examples c0100C a command to cancel the existing call.
c003D also a command to cancel the existing call.
c0110B a command to delete the currently held SDM.
[CANCEL_TYPE] Function
0
(cancel call)
Cancel Call
In conventional mode, Cancel can do the following:
■ clear down a Selcall call, including retries
■ cancel deferred calling
■ take the radio out of emergency operation if in Emergency
Tx/Rx cycles by resetting the radio
In trunked mode, Cancel can do the following:
■ act as though the front panel ‘Cancel’ key has been
pressed.
1
(delete SDM)
Delete SDM data of the last received SDM (if any). Available in
conventional mode only.