EasyManuals Logo

Tait TM8100 Protocol Manual

Tait TM8100
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
66 CCR TM8100/TM8200 Computer-Controlled Data Interface (CCDI) Protocol Manual
© Tait Electronics Limited April 2007
Command
Sssx...xcc
Where:
The Set Selcall Parameter command (see below) allows the user to change
the Selcall parameter defaults.
Effect This command has immediate effect, provided that the receiver and
transmitter frequency values have been initialised and the radio is not
transmitting at the time (PTT active causes busy error)
2.8.10 Set Selcall Parameters
Description This command allows the user to modify the Selcall default parameters (tone
set to use, tone period, number of tones in Tx sequence and number of
tones in Rx sequence). If any of the command parameters are out of range,
a NAK (range error) will be sent back to the control head.
Command I03tplcc
Parameter Value
S ASCII letter S denotes the Transmit Selcall tone sequence
ss ASCII hex number ss is the number of characters for parameters
x...x ASCII number x...x is the tone sequence. Minimum is 2 tones and
maximum is 33.
cc ASCII hex number cc is the checksum

Table of Contents

Other manuals for Tait TM8100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tait TM8100 and is the answer not in the manual?

Tait TM8100 Specifications

General IconGeneral
BrandTait
ModelTM8100
CategoryRadio
LanguageEnglish

Related product manuals