TM8100/TM8200 Computer-Controlled Data Interface (CCDI) Protocol Manual CCR 69
© Tait Electronics Limited April 2007
2.8.13 Transmitter Output Power
Description The transmitter output power is set to the value selected. If the index is
incorrect the command is rejected (NAK-format error).
Important The radio may restrict the transmitter output power
depending on the programmed transmit frequency, in
accordance with regulatory requirements.
Command P01xcc
Where:
Effect The modified power level takes effect on the next Tx activity; either PTT
or Selcall.
Note If there is a front panel key or programmable input with low power
configured, there is no guarantee that the value set with this com-
mand will represent the effective output power. The radio will use
the state last set with any control.
2.8.14 Set Bandwidth
Description This command sets the operating transmit/receive bandwidth. If the index
number is out of range, the radio does not act on the command and sends a
NAK (range error) back.
Command Hssxcc
Where:
Parameter Value
P ASCII letter P indicates it is a power command
01 ASCII hex number 01 is the number of characters for parameters
x is an index to transmit power level, as follows:
■ ‘1’very low power
■ ‘2’low power
■ ‘3’medium power
■ ‘4’high power
cc ASCII hex number cc is the checksum
To Next Page
Loading...
Need help?
General
