TM8100/TM8200 Computer-Controlled Data Interface (CCDI) Protocol Manual CCR 61
© Tait Electronics Limited April 2007
2.8 CCR Commands
2.8.1 Summary and Examples
The messages in the following table are sent from the DTE to the RU.
In all cases, if the command is received without error by the RU and all the
parameters are valid, the command will be executed and the prompt will be
returned to the DTE. If an error arises, the DTE will be notified with an
appropriate response.
Examples f0200D8 Enter ccr from ccdi
E005B Exit - same effect as “^”
R0945320000087 Set Rx frequency to 453.2MHz
T0945320000085 Set Tx frequency to 453.2MHz
Q01PFE Pulse command, returns “P” when minimum config
exists
P0111E Set power to Very Low
P0141B Set power to High
H01324 Set bandwidth to Wide
H01126 Set bandwidth to Narrow
A0406708E Set Rx ctcss to 67Hz
A0400009B Set Rx ctcss to 0Hz
B0406708D Set Tx ctcss to 67Hz
B0400009A Set Tx ctcss to 0Hz
C03023C5 Set Rx DCS to 23
C03000CA Set Rx DCS to 0
D03023C4 Set Tx DCS to 23
D03000C9 Set Tx DCS to 0
S051234549 Dial 12345
Message Cmd Function
Rssxxxxxxxxxcc R Go to Receive Frequency
Tssxxxxxxxxxcc T Load Transmit Frequency
Hssxcc H Set Bandwidth
Jssxxxcc J Set Volume Level
Assxxxxcc A Receive CTCSS Value
Bssxxxxcc B Transmit CTCSS Value
Cssxxxxcc C Receive DCS Value
Dssxxxxcc D Transmit DCS Value
Sssxxxxxcc S Encode Selcall Sequence
Isstplcc I Set Selcall Parameters
Nsspxxxxxcc N Set ANI
Pssxcc P Transmitter Output Power
Qssxcc Q Query Radio Pulse
Esscc E Exit CCR Mode
To Next Page
Loading...
Need help?
General
