EasyManuals Logo

Tait TM8100 Protocol Manual

Tait TM8100
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
TM8100/TM8200 Computer-Controlled Data Interface (CCDI) Protocol Manual CCDI 29
© Tait Electronics Limited April 2007
1.9.4 GO_TO_CHANNEL
The GO_TO_CHANNEL command tells the radio to change to another
conventional mode channel. The specified channel can be assigned to a
scan/vote group in the radio. A trunked radio must change to a conventional
channel before executing this command.
Format g [SIZE] [ZONE] [CHANNEL_NO] [CHECKSUM]
‘g’ is sent as a single ASCII character and represents the
GO_TO_CHANNEL command.
[ZONE] (optional for TM8200, not applicable for TM8100) is a two-
character string representing the new zone. When [ZONE] is omitted,
the radio stays in the current zone.
[CHANNEL_NO] is a maximum of four characters representing the
new channel number. The range of allowed characters is 0 to 9. and must
be a valid channel for the radio. If used with the [ZONE] parameter, this
will always be a four-character string.
Note If the radio is using a scan/vote group when it receives this com-
mand, it will retune to the specified channel.
Note If the radio is in emergency mode then no channel change will
occur, and a ‘not ready’ error message is returned.
Examples g0223D2 go to channel 23.
g0414995E go to channel 1499.
g060100120F go to zone 1, channel 12.

Table of Contents

Other manuals for Tait TM8100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tait TM8100 and is the answer not in the manual?

Tait TM8100 Specifications

General IconGeneral
BrandTait
ModelTM8100
CategoryRadio
LanguageEnglish

Related product manuals