Operating in conventional mode 51
Suspending a channel from a scan group
If a member channel of a scan group is busy for a long
time and you do not want to hear the conversation, you
may be able to use the function key programmed for
nuisance delete to temporarily delete it from the scan
group. When the scan group is next selected, or after
the radio has been turned off and then on, the deleted
channel is again part of the scan group.
To remove a channel from a scan group:
1 Wait until the radio has stopped on the channel that
you want to remove from the scan group.
2 Press the function key programmed for
nuisance
delete.
If the channel has been removed successfully, the
message
Channel nuisance deleted appears in the
display.
The channel remains removed from the scan group
until you either select another scan group or the
radio is turned off and then on again.
Note: The function key programmed to activate
scanning may be programmed so that a short key press
activates scanning and a long key press activates
nuisance
delete.
Channel
nuisance
deleted
To Next Page
Loading...
