Operating in P25 trunking mode 63
Scanning a group of talkgroups
The scan feature is used to monitor a group of trunked
talkgroups for activity. Each group of talkgroups is
programmed as a single scan group.
When there is a call from a member of the talkgroup
scan group, the radio unmutes and you can hear the
call. Calls from talkgroups programmed as ‘priority’
talkgroups, take precedence over those from a non-
priority talkgroup.
While the radio is scanning for activity, the amber LED
glows and
appears in the display. When the radio
stops on a talkgroup where there is activity, the amber
LED and
symbol flash.
Activating talkgroup scanning
Talkgroup scan is turned on using a programmed
function key. When the function key activates talkgroup
scan, the currently selected talkgroup automatically
becomes a member of the talkgroup scan group.
To turn talkgroup scan on:
■ Press the function key.
Suspending a channel from a talkgroup
scan
group
If a member channel of a talkgroup scan group is busy
for a long time and you do not want to hear the
conversation, you may be able to use the function key
programmed for nuisance delete to temporarily delete
the talkgroup from the scan group. When the talkgroup
scan group is next selected, or after the radio has been
turned off and then on, the deleted talkgroup is again
part of the talkgroup scan group.
Group 1
Zone 11
Menu
To Next Page
Loading...
