54 About battery charging
Charging and caring for batteries
Charging the battery
Important: If you are charging the battery for the first
time, follow the instructions on page 4.
1 Ensure that the charger is connected to the correct
Tait power adaptor.
2 Put the battery in the charger.
Note: If you’re putting the radio in the charger as
well, you can leave it turned on if you're expecting a
call. The battery still receives a full charge.
If a radio is attached, the ‘battery in charger’
symbol appears in the radio display.
The red ‘Charging’ LED glows to indicate that the
battery is charging. For a battery that is almost
completely discharged, allow 2 hours.
Note: If the amber ‘Fault’ LED lights up, refer to
“Troubleshooting your charger” on page 61.
3 When the green ‘Ready’ LED on the charger glows,
the battery is fully charged. Remove it when you are
ready—the charger will not overcharge the battery.
You can put the battery in the
charger either with or without
the radio
To Next Page
Loading...
