Takeuchi TL10 User Manual

5-25
MAINTENANCE
AFTER THE INITIAL 50 HOURS (ONLY FOR NEW MACHINES)
10. Turn the filter (4) counterclockwise with
the filter wrench and remove it.
11. Clean the surface of installation of the
filter stand.
12. Apply a thin layer of oil on the packing of
the new filter.
13. Install the new filter by hand.
14. Securely tighten the filter by hand after its
packing comes in contact with the
surface of installation.
15. Add oil up to between the upper limit (H)
and the lower limit (L) of the dipstick (1).
Problems could arise if the oil level is
either too low or too high.
16. Tighten the oil filler cap (2).
17. Lower the canopy.
18. Start the engine, run it at low idle for
about 5 minutes, then stop it.
19. After about 10 minutes, inspect the oil
level.
<TL8>
<TL10/TL12>

Takeuchi TL10 Specifications

General

Engine Make	Kubota
Engine Power	74.3 hp
Tipping Load	7, 205 lb
Rated Operating Capacity	2, 522 lbs
Engine Model	V3307-CR-TE4
Max Dump Height	2, 540 mm
Overall Width	1, 800 mm
Overall Height	2, 540 mm
Travel Speed	11.5 km/h