Takeuchi TL10 User Manual

5-54
MAINTENANCE
EVERY 1500 HOURS
EVERY 1500 HOURS
REPLACING THE OIL SEPARATOR
ELEMENT
1. Open the rear door and radiator. (TL8)
Refer to “Inspecting and adjusting the fan
belt” on pages 5-28 to 5-29.
1. Tilt up the canopy. (TL10/TL12)
Refer to “Tilting up the canopy” on page
5-61.
<TL8>
<TL10/TL12>
INSPECTING THE INJECTOR TIP
This operation requires experience. Ask your
sales or service dealer for it.
INSPECTING THE EGR COOLER
This operation requires experience. Ask your
sales or service dealer for it.
INSPECTING THE PCV VALVE (TL10/TL12)
This operation requires experience. Ask your
sales or service dealer for it.
2. Remove the cover (1) and remove it.
3. Remove the element (2) and the gasket
(3).
4. Wipe off the oil and grease on the case
(4).
5. Set the new element and gasket in the
case (4).
6. Tighten the cover (1).

Takeuchi TL10 Specifications

General

Engine Make	Kubota
Engine Power	74.3 hp
Tipping Load	7, 205 lb
Rated Operating Capacity	2, 522 lbs
Engine Model	V3307-CR-TE4
Max Dump Height	2, 540 mm
Overall Width	1, 800 mm
Overall Height	2, 540 mm
Travel Speed	11.5 km/h