6-5
TROUBLESHOOTING
Disconnecting the jumper cables
Once the dead machine is successfully
running, remove the jumper cables by
following the same steps as for connection in
the reverse order.
IF THE BATTERY GOES DEAD
1. Disconnect the clip of jumper cable (B)
from the engine block of the dead
machine.
2. Disconnect the other clip of jumper cable
(B) from the negative (–) battery terminal of
the booster vehicle.
3. Disconnect the clip of jumper cable (R)
from the positive (+) battery terminal of the
booster vehicle.
4. Disconnect the clip of jumper cable (R)
from the positive (+) battery terminal of the
dead machine.
Recharging
Ask your sales or service dealer for
recharging the dead battery.
To Next Page
Loading...
