Takeuchi TL10 User Manual

2-7
CONTROLS
6. Get in the cab and insert the lock pin (5)
into the pin hole on the cab to lock it.
Closing (from inside)
CAB
1. Remove the lock pin (5) from the pin hole
on the cab to release the door lock.
2. Push the release lever (6) to the front to
release the latch.
3. Grasp the handle (4) and slowly lower the
door.
4. When the door reaches all the way down,
grasp the handle (7) and firmly push the
door in to engage the latch.
Opening (from inside)
1. Push the release lever (6) to the front to
release the latch.
If the release lever (6) does not work,
move the emergency unlock lever (9) to
the left to release the latch.
2. Pull the handle (7) toward you and open
the door.
3. Grasp the handle (4) and lift the door.
4. When the door reaches all the way up,
firmly push the door in to engage the
latch.
5. Check that the door is securely latched
and not moving.
6. Insert the lock pin (5) into the pin hole on
the cab to lock it.

Takeuchi TL10 Specifications

General

Engine Make	Kubota
Engine Power	74.3 hp
Tipping Load	7, 205 lb
Rated Operating Capacity	2, 522 lbs
Engine Model	V3307-CR-TE4
Max Dump Height	2, 540 mm
Overall Width	1, 800 mm
Overall Height	2, 540 mm
Travel Speed	11.5 km/h