What to do if paper cannot be loaded into Tally Dascom Printer?
If paper cannot be loaded or fed into your Tally Dascom printer: * Make sure that the paper select lever located on the top right of the printer is set correctly. Move the lever to the front for single sheets or to the rear for continuous forms. * Make sure that the paper covers the paper-out sensor.
Why does paper slip off the tractors on my Tally Dascom 1225 Printer?
If paper slips off the forms tractors or the perforated holes tear during printing with your Tally Dascom printer, make sure that the forms tractors are positioned correctly for the width of your paper and that the perforated holes of the paper fit directly over the tractor pins.
Why is my Tally Dascom Printer double spacing lines?
If your Tally Dascom printer is double spacing lines instead of single spacing, change the Auto LF setting in the System Setup menu to No.
Why does my Tally Dascom Printer overprint on the same line?
If your Tally Dascom printer is overprinting on the same line, change the Auto CR setting in the System Setup menu to No.
Why does the next print line start where the previous line ended on my Tally Dascom Printer?
If the next print line starts where the previous line ended instead of at the left margin on your Tally Dascom printer, change the Auto CR setting in the System Setup menu to Yes.
What does paper select lever error mean on Tally Dascom 1225 Printer?
If paper is loaded and the paper select lever is moved to the incorrect position, the Tally Dascom printer turns offline, and the buzzer sounds continuously. Switch the paper select lever back to its correct position.
Step-by-step guide to install or remove the printer's ribbon cartridge.
Procedure for connecting power and installing necessary printer drivers.
How to adjust the print gap lever for different paper thicknesses and copy counts.
Steps for cleaning the printer's exterior, interior, and print head carriage.
Diagnosing and fixing issues related to print darkness, smears, and alignment.
Troubleshooting paper jams, loading errors, and operational failures.
Interpreting LED patterns to identify printer errors and failures.
Comprehensive list of control codes for Epson emulation mode.
Comprehensive list of control codes for IBM emulation mode.
General| Type | Dot Matrix Printer |
|---|---|
| Print Technology | Impact |
| Print Width | 80 columns |
| Print Resolution | 360 x 360 dpi |
| Paper Size | A4 |
| Paper Handling | Friction feed |
| Interface | Parallel |
| Noise Level | 55 dB |
| Number of Pins | 24-pin |
To Next Page
