Tally Dascom DL-210 - Barcode commands; Bit image commands

Tally Dascom DL-210 User Guide V1.3
68
Category
Commands
Function
Character control
commands
ESC SP n
Set right-side character spacing
ESC ! n
Select print mode(s)
ESC % n
Select/cancel user-defined character
set
ESC & y c1 c2 [x1 d1...d(y ×
x1)]...[xk d1...d(y × xk)]
Define user-defined characters
ESC - n
Turn on/off underline mode
ESC ? n
Cancel user-defined characters
ESC E n
Turn emphasized mode on/off
ESC G n
Turn double-strike mode on/off
ESC M n
Select character font
ESC R n
Select an international character set
ESC V n
Turn on/off 90 degrees clockwise
rotation mode
ESC { n
Turn on/off upside-down print mode
GS ! n
Select character size
GS B n
Turn white/black reverse print mode
on/off
Barcode
commands
GS H n
Select print position of HRI
characters
GS f n
Select font for HRI characters
GS h n
Set bar code height
①GS k m d1...dk NUL
②GS k m n d1...dn
Print bar code
GS w n
Set barcode width
ESC Z m n k dL dH d1 …dn
Print 2D barcode
GS Z n
Select 2D barcode type
①GS k m v r d1...dn NUL
②GS k m v r nL nH d1...dn
Print 2D barcode
Bit image
commands
ESC * m nL nH d1... Dk
Select bit-image mode
FS P n
Print NV bit image
GS * x y d1...d(x × y × 8)
Define downloaded bit image