Tally Dascom 1125
35
printed above.
7 . Once the setting which gives the best alignment is found, press 【Online】 key to exit current level.
Printer will print “Save settings? Yes”. Press 【LF/FF】 key to save setting. Press 【Online】 key a few
times until the printer exits the Service Menu.
Change Pin Function
When printer has been used for a long time or the print volume is high, the frequently used print head pins may
fail. The Change Pin function enables the user to continue using the printer for a while without compromise in
print quality until a suitable print head replacement is available. This function will reduce the print speed if
activated.
Change Pin Procedure:
1. Enter the Service Menu by holding down the【Tear/Off】and【LF/FF】keys while powering up.
2. Load paper.
3. The printer will print as below:
Service Menu
【LF/FF】=OK 【Tear/Off】= Back 【Load/Eject】= Next 【Online】= Exit
Current Menu：Vertical Alignment
Press 【Load/Eject】 key to scroll to “Change Pin”，then press 【LF/FF】 key to select. The status
of each pin will be printed as follows:
Change Pin
1 ---------- Is this pin OK? Yes / No
2 ---------- Is this pin OK? Yes / No
3 ---------- Is this pin OK? Yes / No
:
24 ---------- Is this pin OK? Yes / No
Press【Load/Eject】key to choose whether the pin is Yes or No，then press【LF/FF】 key to confirm
selection.
4. When all the 24 pins are evaluated, press【Online】. The printer will print “Save settings? Yes”. Press
【LF/FF】key to confirm selection. Press【Online】key a few times until the printer exits the Service
Menu.
To Next Page
Loading...
