Tascam CD-BT2 - Using Bass with the Trainer: Effects; Applying Built-in Bass Effects; Effect Bank Selection

IMPORTANT SAFETY INSTRUCTIONS
31 TASCAM CD-BT2
Using a bass with the trainer
3 Use the VALUE (+, –) keys to adjust the level. The level
knob icon rotates as you change the value.
NOTE
The input meter at the bottom of this screen shows the
level of the signal input at the BASS IN jack.
Using built-in effects
This device has a built-in multi-effects processor for bass
guitar. Press the EFFECT key to open the EFFECTOR screen.
On the EFFECTOR screen, use the CURSOR (§, ¶) keys to
select items and the VALUE (+, –) keys to adjust settings in the
same way as on other screens. Use the CURSOR (˙, ¥) keys
to move between level knobs and effect modules.
As shown in the gure above, in addition to BANK and
PRESET, the EFFECTOR screen also shows the LVL (level)
knob and icons for up to four bass effect modules. All icons
have adjustable settings.
When you select the LVL knob or effect modules, a pop-up
appears for the setting items. Use the CURSOR (§, ¶) keys to
select settings in the pop-up, and use the VALUE (+, –) keys to
adjust these settings.
BANK
Select bank 01–10 or BYPASS.
Using the PRESET item explained below, you can set a
preset effect for each bank. By making presets of settings that
you use frequently in each bank, you can quickly recall the
settings you desire just by switching through the banks.
Select BYPASS if you do not want to use effects.