32
10 Force adjustment on
obstacle in CLOSING
Adjustment of the impact force on
any obstacle during closing.
(0.0 = sensitivity disabled -
0.1 = maximum sensitivity -
9.9 = minimum sensitivity)
from
0.0. to
9.9.
3.5
11 Force adjustment
on obstacle during
OPEN deceleration
Adjustment of the impact force on
any obstacle during deceleration in
opening. (0.0 = sensitivity disabled -
0.1 = maximum sensitivity -
9.9 = minimum sensitivity)
from
0.0. to
9.9.
3.5
12 Adjustment of force
on obstacle during
CLOSING deceleration
Adjustment of the impact force on
any obstacle during the decelera-
tion in closing.
(0.0 = sensitivity disabled -
0.1 = maximum sensitivity -
9.9 = minimum sensitivity)
from
0.0. to
9.9.
3.5
13 Adjustment of the
inversion time from
photocell interven-
tion
It adjusts the time that elapses
between stopping and reversing
after the intervention of the pho-
tocell
from 0.3.
to 2.0.
(tenths
of s)
3.5
14 Final kick in closing
after limit switch
Time of inversion on the limit switch
intervention to decrease inertia.
(0.0. = Function not active from 0.1.
To 2.0. = Inversion time expressed
in tenths of a s.)
from
0.3. to
2.0.
0.0.
15 NOT USED Set the value to 0.0. 0.0.
16 Operation counter It indicates the total number of au-
tomation maneuvers. By entering
function 16, the gures correspon-
ding to the hundred-thousand and
ten-thousand will be presented;
by pressing the P2 key, it will go to
the thousands and hundreds; by
pressing P2 again, it will display
the digits corresponding to the
tens and units.
n. ma-
neuvers
17 NOT USED
18 OPEN/CLOSE fun-
ction selection
By enabling the function, the START
input becomes OPEN and the PE-
DESTRIAN START becomes CLOSE.
(yes = enable/no = disable)
YES and
NO
NO
19 NOT USED
To Next Page
Loading...
