Taurus RX7 - Equipment Assembly Process; Assembly Best Practices

RX7
11
2 ASSEMBLY
2.1 General Instructions
⚠ DANGER
+ Do not leave any tools, packaging materials such as foils or small parts lying around, as
otherwise there is a danger of suocation for children. Keep children away from the equipment
during assembly.
⚠ WARNING
+ Pay attention to the instructions attached to the equipment in order to reduce the risk of
injuries.
⚠ CAUTION
+ Do not open the packaging when it is lying on its side.
+ Ensure to have sucient room for movement in each direction during assembly.
+ The assembly of the equipment must be carried out by at least two adults. If in doubt, seek the
help of another technically skilled person.
 ATTENTION
+ To prevent damage to the equipment and the oor, assemble the equipment on a mat or
packaging board.
L NOTICE
+ In order to make the assembly as simple as possible, some screws and nuts to be used can
already be pre-assembled.
+ Ideally, assemble the equipment at its later set-up place.
+ Manufacturer note: The pull strap is equipped with a return spring so that the pull strap is
automatically wound up again. The return spring is equipped with the lowest possible power.
The reason for the light return spring is to give the user a better training eect for the rear
thigh muscles. These muscles are stressed when the user moves the seat forward. If the return
power is strong, the person using the equipment would be pulled.