RX7
56
5.3 Maintenance and Inspection Calendar
To avoid damage from body sweat, the equipment must be cleaned with a damp towel (no solvents!)
after each training session.
The following routine tasks must be performed at the specied intervals:
Part Weekly Monthly Quarterly Half-yearly Yearly
Display console
C I
Lubrication of moving
parts
I
Plastic covers
C I
Screws and cable
connections
I
Legend: C = clean; I = inspect
Pull strap
The pull strap is made of high-quality nylon fabric and extremely resilient. It is nearly impossible to
tear the pull strap. Nevertheless, it is important to inspect it for wear. Make sure that there are no
cuts or frays or other types of damage. Also check the seam on the handle. If you determine any
impairments, you should no longer use the rowing machine until you have replaced the pull strap.
Footrest
The footrest has many mobile parts and it is important that they are always in a good state. Check if
the buckle and the foot loop are connected with each other. Check to see if the locking mechanism
from the footrest works properly as well. Make sure that all screws are tight. If you determine any
errors, contact your contract partner immediately and use the rowing machine again only after it
has been repaired.
6 DISPOSAL
At the end of its operational life, this equipment cannot be disposed of in normal household waste.
Instead, it must be disposed of via an electricals recycling centre. Further information can be
obtained from your local authority‘s recycling service.
The materials can be recycled as per their symbols. Through the reuse, recycling
of materials or other forms of recovery of old equipment, you make an important
contribution to the protection of the environment.
Pb = Battery contains more than 0.004 percent by weight of lead.
Cd = Battery contains more than 0.002 percent by weight of cadmium.
Hg = Battery contains more than 0.0005 percent by weight of mercury.
To Next Page
Loading...