Taurus RX7 - Angle of the Infrared Transmitter from the Handle; Code from the Remote Control

RX7
47
3.5.7 ANGLE OF THE INFRARED TRANSMITTER FROM THE HANDLE
3.5.8 Code from the remote control
The code from the remote control (or RMC code in short) allows you to reprogram the code from the
infrared remote control. There are two reasons to reprogram the RMC code:
1. There are several rowing machines with remote controls nearby and the infrared rays overlap. This
may be the case at health clubs and commercial facilities.
2. Disruption with existing infrared signals, for example, television or TV remote control, etc. This
happens primarily with home use.
 ATTENTION
Do not reprogram the RMC code as long as it is not necessary, because the infrared remote
control may stop working if you make a mistake.
Step 1
1. Place the handle in the handle holder and
avoid touching the handle again until step 3.
In the gure the infrared
transmitter of the
handle points upwards
and downwards, so it
does not point towards
the infrared receiver of
the computer.
Wrong
Right
In the gure the infrared
transmitter of the handle
points directly towards
the infrared receiver of
the computer.
Handlebar
Handlebar
holder