12
2.3 Error codes and troubleshooting
The electronic system from the treadmill executes tests continually. If there are
deviations, an error code will be displayed and the normal operation will be stopped
for your safety.
Please contact your contract partner for technical customer service.
+ E1 - Speed value cannot be recorded. Either the motor is broken or the signal
cannot be transmitted.
+ E6 - Incline values are incorrect. The incline motor is broken or the signal cannot
be transmitted.
+ E7 - Incline AD is above the normal value. The incline motor is broken or an
incorrect setting was made.
2.4 Care and maintenance
The most important maintenance measure is taking care of the running belt. It
includes the adjustment, tensioning and lubrication of the running belt. Damage
caused due to a lack of care or negligence will not be covered by the warranty. Thus,
check for maintenance in regular intervals. Be extremely careful when adjusting and
tensioning the belt, because a strong over or under tension may cause damages. The
running belt is set properly in the factory before delivery. However, the running belt
may get out of place during transport.
Aligning the running mat
+ During training, the running belt should run as centered and straight as possible.
The alignment of the running belt may change depending on the stress and load.
Another reason can be the positioning of the equipment on an uneven surface.
+ While adjusting the belt, let the equipment run with a speed of approximately
5km/h. Nobody may be on the equipment during this process.
+ If the running belt is oset to the left, turn the left setting screw on the rear end of
the equipment at most 1/4 rotation clockwise and the right setting screw at most
1/4 rotation counterclockwise (g. C).
To Next Page
Loading...
