14
Lubricating the running belt
+ If the running belt is inadequately lubricated, the friction will increase signicantly
and this leads to strong wear of the endless belt, running panel, motor and circuit
board.
+ If you feel an increase in friction from the running belt, this is an indicator that you
should lubricate the belt (however, a lubrication should be done at least every
three months).
+ The treadmill has a reminder for lubricating the treadmill: A symbol is displayed on
the console every 100 operating hours. The symbol appears on the display for ve
minutes and then turns o. In order to turn o the symbol prematurely, press the
INCLINE up and INCLINE down buttons at the same time.
+ In order to be able to optimally lubricate the treadmill, the running belt must be
lifted slightly. Then apply some silicone spray on the entire running deck. Apply
three short (approximately 1 second) sprays of silicone lubricant between the belt
and the running deck.
+ The spraying tube should be held sideways in order to guarantee a moistening of
the entire underside of the belt. Continue to rotate the belt by hand so that the
entire area between the endless belt and running deck is lubricated. Wipe o the
excess lubricant.
+ This maintenance must also be executed after the equipment has not been used
for a longer period of time.
2.5 Maintenance and service calendar
The cockpit, casing, handrails and entire frame must be cleaned after every training
session with a moist towel (no solvent!) in order to avoid damage caused by sweat.
After 150 hours of operation, the maintenance symbol reminds you to clean the
treadmill. After you have cleaned the treadmill and checked all components, turn o
the symbol by simultaneously pressing the INCLINE up and INCLINE down buttons.
To Next Page
Loading...
