Taylor 62 User Manual

Section 1
1-1
Models 60 and 62
To the Installer
1
To the Installer
The following information has been included in the
manual as safety and regulatory guidelines. For complete
installation instructions, please see the installation
checklist.
Installer Safety
IMPORTANT! In all areas of the world,
machines should be installed in accordance with existing
local codes. Please contact your local authorities if you
have any questions.
Care should be taken to ensure that all basic safety
practices are followed during the installation and
servicing of Taylor machines.
• Only Taylor service technicians should perform
installation, maintenance, and repairs on Taylor
machines.
• Taylor service technicians should consult OSHA
Standard 29CFRI910.147 or the applicable
code of the local area for industry standards on
lockout/tagout procedures before beginning any
installation or repairs.
• Taylor service technicians must ensure that the
proper personal protective equipment (PPE) is
available and worn when required during
installation and service.
• Taylor service technicians must remove all
metal jewelry, rings, and watches before
working on electrical equipment.
DANGER! The main power supply(s) to the
machine must be disconnected prior to performing any
installation, maintenance, or repairs. Failure to follow this
instruction may result in personal injury or death from
electrical shock or hazardous moving parts, as well as
poor performance or damage to the machine.
WARNING! This machine has many sharp
edges that can cause severe injuries.
Site Preparation
Review the area where the machine will be installed
before uncrating it. Make sure all possible hazards to the
user or machine have been addressed.
Uncrate the machine and inspect it for damage. Report
any damage to the Taylor distributor.
This machine is made in the USA and uses USA
hardware sizes. All metric conversions are approximate.
For Indoor Use Only: This machine is designed to
operate indoors, under normal ambient temperatures of

70°F to 75°F (21°C to 24°C). The freezer has
successfully performed in high ambient temperatures of
104
°F (40°C) at reduced capacities.
WARNING! This machine must NOT be
installed in an area where a water jet or hose can be
used. NEVER use a water jet or hose to rinse or clean
the machine. Failure to follow this instruction may result
in electrocution.
CAUTION! This machine must be installed on
a level surface to avoid the hazard of tipping. Extreme
care should be taken in moving this machine for any
reason. Two or more persons are required to safely move
this machine. Failure to comply may result in personal
injury or machine damage.

Taylor 62 Specifications

General

Brand	Taylor
Model	62
Category	Freezer
Language	English