Taylor C712 - Pump Checklist

C712 Operator Training -15-
Pump Checklist
1. Dispose of o-rings and seals if they are worn, torn, or fit too loosely. Replace with new ones.
2. Follow all lubricating procedures carefully.
3. To avoid nicks and cracks, handle plastic pump parts with care.
4. Be sure the air/mix pump is properly attached to the drive hub, or severe and costly damage
may occur.
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________