C712 Operator Training -23-
Door
No product is being dispensed.
Cause: Low on mix. The MIX OUT light is on.
Remedy: Add mix to the mix hopper. Return to AUTO mode.
Cause: The power switch is in the OFF position.
Remedy: Place the power switch in the ON position and select AUTO.
Cause: Beater motor is out on reset, BEATER OVERLOAD message displayed.
Remedy: Turn the machine off. Press the reset button. Restart the machine in AUTO.
Cause: Machine not in AUTO mode.
Remedy: Select AUTO and allow machine to cycle off before drawing product.
Cause: The feed tube or check ring is not properly installed.
Remedy: Make sure the feed tube or check ring is properly installed.
Cause: The pump motor is not running in the AUTO mode.
Remedy: Push the pump reset button. Check if the pump motor is operating when the draw
valve is raised.
Cause: Freeze-up in mix inlet hole.
Remedy: Call an authorized service technician.
Cause: The mix pump ball crank is broken.
Remedy: Call an authorized service technician.
Product is collecting on top of the freezer door.
Cause: The top o-ring on the draw valve is improperly lubricated or worn.
Remedy: Lubricate properly or replace the o-ring.
Excessive mix leakage from the bottom of the door spout.
Cause: Bottom o-ring on the draw valve is improperly lubricated or worn.
Remedy: Lubricate properly or replace the o-ring.
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
___________________________________________________________________________
To Next Page
Loading...
