62
12. Remove the release sheet locking clips and the
upper release sheets. Wash and rinse the clips in the
three-compartment sink. If necessary, soak them in a
hot solution of SolidSense APSC to remove carbon
accumulation.
See Figure-145.
Figure-145
13. Place all of the release sheets clean side down flat
on the release sheet storage tray.
See Figure-146.
Figure-146
14. Spray a clean, sanitizer-soaked grill cloth once with
grill cleaner. Wipe the soiled side of the release sheet
until clean.
See Figure-147.
Figure-147
15. Rinse with a separate clean, sanitizer-soaked grill
cloth to rinse off the remaining grill cleaner. Repeat
for all of the release sheets.
See Figure-148.
Figure-148
16. Remove the rear grease guard and take it to the
three-compartment sink to wash, rinse, and sanitize.
See Figure-149.
Figure-149
17. Spray the upper platens with grill cleaner, starting
with the sides and back. If you have three upper
platens, lower the middle platen first to easily access
the adjoining sides of the right and left platens.
18. After spraying the sides, spray the surface of each
upper platen three times to cover the bottom, middle,
and top.
See Figure-150.