6-10
OPERATING PROCEDURES
Models 8752 and 8756 with HorizonĀ® Pump
Operating Procedures
6
5. Place an empty pail beneath the door spout and raise
the prime plug.
Figure 6-39
6. Press the WASH and PUMP buttons. The lights will
come on, indicating the pump and beater motor are
operating. When a steady stream of sanitizing
solution is flowing from the prime plug hole in the
bottom of the freezer door, press the PUMP button,
stopping pump operation. Push down the prime plug
and allow beater agitation for 5 minutes.
Figure 6-40
7. After 5 minutes, open the prime plug. Press the
PUMP button. Pull the draw handle down and draw
off the remaining sanitizer.
Figure 6-41
Note: On Model 8756, momentarily pull down the
center draw handle to sanitize the center door spout.
8. Once the sanitizer stops flowing from the door spout,
close the draw valve. Press the PUMP and WASH
buttons to stop operation.
9. Disconnect the pressure line from the check valve.
Drain the sanitizer. Reconnect the pressure line to
the check valve.
10. Repeat steps 1 through 9 for the other side of the
freezer on Model 8756.
Airflow Adjustment
Note: Adjust airflow prior to priming the with mix.
1. Open the prime plug.
Figure 6-42
2. Make sure the suction line is open to airflow and is
not inserted in liquid.
3. Press the PUMP button.
To Next Page
Loading...
