6-16
OPERATING PROCEDURES
Models 8752 and 8756 with Horizon® Pump
Operating Procedures
6
8. Using the long, flexible brush and the cleaning
solution, clean the mix inlet tube(s) located in the mix
cabinet. Thoroughly clean the tube(s) all the way up
to the freezing cylinder. This area needs special
attention because bacteria and milkstone can build
up here.
Figure 6-57
Important!
• Do not insert a brush into the pump tube.
• Do not remove the pump tube when cleaning
the machine.
Note: The pump tube is located inside the Horizon
®
pump.
9. Remove the rear drip pan from the side panel and
take it to the sink for cleaning.
Note: If the rear drip pan is filled with an excessive
amount of mix, see the Troubleshooting Guide.
10. Thoroughly clean all disassembled parts in the
cleaning solution, making sure all lubricant and mix
film is removed. Take particular care to clean the
draw valve core(s) in the freezer door. Place all the
cleaned parts on a clean dry surface to air-dry
overnight.
11. Wipe clean all exterior surfaces of the freezer and the
mix cabinet.
To Next Page
Loading...
