Taylor Tim Hortons 390 User Manual

23
Model 390 Tim Hortons Troubleshooting Guide
Section 8 Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
1. No product being
dispensed.
a. Power switch is in the
“OFF” position.
a. Place power switch in the
“AUTO” position.
18
b. Improper mixing of
product.
b. Carefully follow directions
for mixing product.
- - -
c. Inadequate mix in hopper. c. Fill hopper with mix. 18
d. Product frozen-up in
freezing cylinder.
d. Contact a service
technician.
- - -
e. Unit out on reset. e. Place power switch in the
“OFF” position. Press the
reset button. Return
control switch to “AUTO”.
11
f. Beater assembly is not
rotating at all or is rotating
counterclockwise. Control
switch is not in “AUTO”.
f. The power switch must be
in “AUTO”. If beater is
rotating counterclockwise,
call service technician to
correct rotation.
1
g. Unit unplugged at wall
receptacle.
g. Plug in power cord. - - -
h. Tripped circuit breaker or
blown fuse.
h. Reset circuit breaker or
replace fuse.
- - -
2. Unit will not operate in the
“AUTO” or “WASH” mode.
a. Unit unplugged at wall
receptacle.
a. Plug in power cord. - - -
b. Tripped circuit breaker or
blown fuse.
b. Reset circuit breaker or
replace fuse.
- - -
c. Unit out on reset. c. Place the power switch in
the “OFF” position. Press
the reset button. Return
control switch to “AUTO”.
11
3. No compressor operation
in the “AUTO” mode.
a. Beater motor is out on
overload.
a. Place control switch in
“OFF” position. Press the
reset button. Return
control switch to “AUTO”.
11
b. Condenser dirty A/C. b. Clean condenser monthly. 21
c. The “CLEANING REQ'D”
light is lit.
c. Clean the unit according
to instructions in the
Operator's Manual.
19

Taylor Tim Hortons 390 Specifications

General

Brand	Taylor
Model	Tim Hortons 390
Category	Freezer
Language	English