TC Electronic Ditto User Manual

Setup examples
Ditto Stereo Looper English Manual 6
Setup example 2: Ditto Stereo Looper and effects
Place your effects before Ditto Stereo Looper.
This will allow you to create and record different
sounds within the same looping session simply
by switching your effects on and off.
You should also make sure to go from mono ef-
fects (typically distortion and drive pedals) to
stereo effects (modulation, stereo delays etc.).
Stereo effect pedals
Drive
pedal
Combos

TC Electronic Ditto Specifications

General

Type	Looper Pedal
Looping Time	5 minutes
True Bypass	Yes
Power Supply	9V DC
Mono/Stereo	Mono
Number of Loops	1
Undo/Redo	Yes
Input Impedance	1 MΩ
Output Impedance	100 Ω
Power Supply (center negative)	Yes
Current Draw	100 mA
Dimensions	48 x 48 x 93 mm
Weight	300 g