TC Electronic Ditto User Manual

Setup examples
Ditto Stereo Looper English Manual 7
Setup example 3: Ditto Stereo Looper in an FX loop
If you are using an amp or a mixer with a stereo
FX loop, place your modulation effects and Dit-
to Stereo Looper in that FX loop. Again: To get
the most out of your setup, place Ditto Stereo
Looper at the end of the FX loop. This gives you
the flexibility to add parts with or without signal
processing by simply switching effects on and
off as required.
◄ FX Loop Send
FX Loop Return ►
Reverb, delay and
modulation pedals
Combo or mixer
Drive Pedal(s)

TC Electronic Ditto Specifications

General

Type	Looper Pedal
Looping Time	5 minutes
True Bypass	Yes
Power Supply	9V DC
Mono/Stereo	Mono
Number of Loops	1
Undo/Redo	Yes
Input Impedance	1 MΩ
Output Impedance	100 Ω
Power Supply (center negative)	Yes
Current Draw	100 mA
Dimensions	48 x 48 x 93 mm
Weight	300 g