Adjusting
Bass,
Midrange,
Treble, and Balance
of
Speakers
TONE
DIRECT
o 10 0 0
(go@
Each
time
you press the
DIMMER
button, the display changes
as
follows:
NORMAL (Normal)
+
DIMMER
(Dimmed)
+
LIGHT
OFF
(Display off)
o Select
the
item
to adjust.
VOLUME/SET
Each
time
you
press
the
VOLUME/SET
knob, the display changes
as
follows:
VOLUME
(volume)
+
BASS
+
MID
+
TREBLE
+
BALANCE
+
DIMMER
•
You
can also use the
SET
button
on the remote cntrol unit.
BASS
Adjusts the level
of
low
frequency sound range. The level can
be adjusted from -12 to
+12.
MID
Adjusts the level
of
middle
frequency sound range. The level
can be adjusted from -12
to
+12.
• This setting
is
not memorized when the
unit
turns into standby.
The next
time
the
unit
is
turned on, the display
is
illuminated
as
normal.
• When the unit
is
operated during the setting
is
"LIGHT
OFF",
the
display turns normal briefly and will turn
off
again.
D Turn
the
VOLUME/SET knob
to
change
the
setting.
VOLUME/SET
•
You
can also
use
the
VOLUME
buttons
(+/-)
on the remote cntrol
unit.
o Leave
the
unit
idle
for 3 seconds to exit
the
setup mode.
Tone Direct
Press
the
TONE
DIRECT
button
to
cancel the
tone
adjustments
temporarily.
TONE
DIRECT
When this function gets active, the Tone Direct indicator lights
up
temporarily.
•
To
cancel the Tone Direct function,
press
the
button
again.
TREBLE
Adjusts the level
of
high frequency sound range. The level can
be adjusted from -12
to
+12.
BALANCE
Adjusts the balance
of
the volume level between left and right
speakers.
FM
CH01
Tone Direct indicator
1
m
98.1MHz
DIMMER
Adjusts the
dimming
level
of
the
display in 3 levels using the
DIMMER
button
ofthe
remote control unit.
• When this function
is
active and no operation
is
done for about
5 seconds,
the
display
is
turned
off
regardless
of
the
dimmer
setting.
13
To Next Page
