16
2 Setting up your DGA4130
DMS3-CTC-25-420 v1.0. Copyright © 2017 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
2.1.2 Local router setup
Procedure
Proceed as follows:
1 Take an Ethernet cable. If your package contains an Ethernet cable with red connectors, you must use that cable.
2 Plug one end of the cable in the red WAN port on the back of your DGA4130.
3 Plug the other end of the cable into the Ethernet port of your Internet access device (for example, an Optical Network
Terminal (ONT) for Fiber).
If you use another Ethernet cable than the one included in your package, make sure that the Ethernet cable is a
fully wired CAT5E or CAT6 Ethernet cable.
The WAN port can only be used to connect your DGA4130 to an Internet access device. You cannot use it to
connect other devices (for example, a computer) to the DGA4130.
To Next Page
Loading...
