23
2 Setting up your DGA4130
DMS3-CTC-25-420 v1.0. Copyright © 2017 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
2.7 Set up a mobile fallback connection
Mobile fallback
Your DGA4130 allows you to use mobile Internet as fallback for your main Internet connection. This means that your
DGA4130 will automatically switch to the mobile Internet connection when your main Internet connection is down.
Your DGA4130 will automatically switch back to the main Internet connection as soon as it becomes available again.
What do I need?
To set up mobile fallback connection, you need:
• A mobile Internet dongle
• A registered Security Identity Module (SIM) card.
Connect your mobile Internet dongle to the DGA4130
Proceed as follows:
1 Make sure that the SIM card is correctly inserted in your mobile Internet dongle.
2 Plug the mobile Internet dongle into an available USB port of your DGA4130.
3 Wait for two minutes to allow your DGA4130 to detect the mobile Internet dongle.
Configure the mobile Internet connection
Proceed as follows:
1 Browse to the DGA4130 web interface.
For more information, see “4.1.1 Accessing the DGA4130 web interface from your local network” on page 40.
2 Click the Mobile 3G/4G card header.
Depending on your subscription, downloading and uploading over the mobile Internet connection may results in
additional charges.
Only use the mobile Internet dongles provided by your service provider.
To Next Page
Loading...
Need help?
General
