17
2 Setting up your DGA4130
DMS3-CTC-25-420 v1.0. Copyright © 2017 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
2.2 Powering on your DGA4130
Procedure
Proceed as follows:
1 Plug the connector of the power supply unit into your DGA4130 power inlet port ( ).
2 Plug the power supply unit into a nearby power outlet.
3 Press the power button to turn on your DGA4130.
4 The LED turns on. Wait at least two minutes to allow your DGA4130 to complete the startup phase.
Only use the power supply unit that is supplied with this product, is supplied by your service provider or local product
dealer, or a replacement power supply unit provided by your service provider or local product dealer.
The use of other types of supplies is prohibited.
If you are not sure of the type of power supply needed, consult the product's user documentation or contact your
service provider or local product dealer.
To Next Page
Loading...
Need help?
General
