81
8 Support
DMS3-CTC-25-420 v1.0. Copyright © 2017 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
2 In the Internet card header, make sure that the switch is in the position.
3 Click Internet and then click show advanced. Make sure that DHCP routed mode is selected.
4 Click Switch connection mode.
5 After a few minutes the Status should switch to Connected. If needed, click refresh data first.
DGA4130 unreachable
If you cannot access your DGA4130 via your web browser, you might consider a hardware reset as described in “8.4 Reset to
factory defaults” on page 85.
To Next Page
Loading...
