Technics OTTAVA f SC-C70MK2 User Manual

50
Operations
Using digital audio output
device
You can connect a DVD player, etc. with
optical digital audio cable (not supplied) and
play back music.
Optical digital audio
cable
(not supplied)
DVD player, etc.
1 Disconnect the AC power supply cord.
2 Connect this unit and a DVD player etc.
3 Connect the AC power supply cord to
this unit. (⇒ 27)
4 Press [
] to turn this unit on.
5 Press [>SELECT<] repeatedly to select
“OPT”.
6 Start playback on the connected device.
Note
• The digital audio input terminal of this unit can
only detect the following linear PCM signals. For
details, refer to the operating instructions of the
connected device.
 Sampling frequency:
32/44.1/48/88.2/96 kHz
 Number of quantization bits:
16/24 bit

Technics OTTAVA f SC-C70MK2 Specifications

General

CD Player	Yes
Bluetooth	Yes
Bluetooth Version	4.2
Bluetooth Codec	SBC, AAC
Bluetooth Profiles	A2DP, AVRCP
USB Playback	Yes
Optical Input	Yes
Ethernet	Yes
Headphone Output	Yes
JENO Engine	Yes
LAPC (Load Adaptive Phase Calibration)	Yes
Impedance	6Ω
Power Supply	AC 220-240V, 50Hz/60Hz
Power Consumption	38W
Speaker Units	Tweeter: 2cm Dome Type x2, Woofer: 8cm Cone Type x2, Subwoofer: 12cm Cone Type x1
Wi-Fi	Yes
Streaming Services	Spotify, TIDAL, Deezer, Internet Radio
Multi-Room	Yes
Type	All-in-one stereo system